Enumerate the step by step switch configuration?

How to configure a network switch

1. Step 1: Connect to the console. ...
2. Step 2: Set a management IP and default gateway. ...
3. Step 3: Set hostname and domain name. ...
4. Step 4: Set logins on VTY lines and console port. ...
5. Step 5: Set Privileged EXEC password. ...
6. Step 6: Enable SSH. ...
7. Step 7: Create VLANs. ...
8. Step 8: Add access ports to a VLAN.

1. Does switch need configuration?
2. Why do we configure switches?
3. What is configuration in networking?
4. What are the steps to configure a VLAN on a switch?
5. How do you enter interface configuration mode?
6. What are the 3 types of switches?
7. What is the correct configuration of hostname?
8. What is the command to configure a hostname on a switch?
9. How does a switch work?

Does switch need configuration?

An unmanaged network switch is designed so that you can simply plug them in and they work, no configuration required.

Why do we configure switches?

Switch allows us to set IP address on interface level. IP address assigned on interface is used to manage that particular interface. ... We also have to set default gateway IP address from global configuration mode. In following example we would assign IP 172.16.

What is configuration in networking?

Network configuration is the process of assigning network settings, policies, flows, and controls. In a virtual network, it's easier to make network configuration changes because physical network devices appliances are replaced by software, removing the need for extensive manual configuration.

What are the steps to configure a VLAN on a switch?

To configure VLANs on a Cisco switch, use the vlan global configuration command. In addition, one can also use the vlan database command in the privileged mode. In this exercise, we will configure VLANs on Switch1 and Switch2. The following table lists the details of topology that we will use.

How do you enter interface configuration mode?

To enter interface configuration mode, enter the interface configuration command. Interface configuration From global configuration mode, specify an interface by entering the interface command followed by an interface identification. To exit to privileged EXEC mode, enter the end command, or press Ctrl-Z.

What are the 3 types of switches?

The three types of mechanical switches are linear, tactile, and clicky.

What is the correct configuration of hostname?

A hostname must start and end with a letter or digit, and have as interior characters only letters, digits, or a hyphen. When you set a hostname for the ASA, that name appears in the command line prompt. If you establish sessions to multiple devices, the hostname helps you keep track of where you enter commands.

What is the command to configure a hostname on a switch?

How to Configure a hostname for a Cisco Switch. To configure a name for router, use "hostname" command from Global Configuration mode.

How does a switch work?

The switch uses the MAC address to identify which attached device outgoing packets are being sent from and where to deliver incoming packets. ... When a device sends a packet to another device, it enters the switch and the switch reads its header to determine what to do with it.