Where is the computer borad for a 2003 Dodge Ram?

1. How do you reset the computer on a 2001 Dodge Ram 1500?
2. How do you reset the computer on a Dodge Ram 2500?
3. Where is the PCM located?
4. How do you reset the TCM on a 2003 Dodge Ram 1500?
5. How do I get my Dodge Ram out of limp mode?
6. How do you reset the security on a 2002 Dodge Ram 1500?
7. How do you reset the computer on a Dodge Cummins?
8. What is a 3057 bulb used for?

How do you reset the computer on a 2001 Dodge Ram 1500?

Turn the ignition to the start position for a count of 30 to 40 seconds. Turn it back off, then go back to Your battery, and replace the negative terminal to it's original connection. The PCM should now be reset.

How do you reset the computer on a Dodge Ram 2500?

Disconnect the negative terminal cable from the battery with a combination wrench. Set the negative terminal cable aside and wait 20 minutes. This will drain the computer's stored electricity and clear its memory. Reconnect the negative terminal cable to the battery.

Where is the PCM located?

The PCM is most often located in the engine bay near the fuse box or inside the car near the fuse box. It can often also be located under the front windshield behind some covers. There are a few different locations that the manufacturer can place your vehicle's PCM, but the most common location is in the engine bay.

How do you reset the TCM on a 2003 Dodge Ram 1500?

Turn your key to the right just before ignition. Press the gas pedal all the way down and hold for 10 seconds. Turn your key to the left to the off position but do NOT remove the key. Wait for 2-3 minutes before removing key.

How do I get my Dodge Ram out of limp mode?

To get the Dodge Ram 1500 out of limp mode you need to stop and shift to park. Turn the car off and wait 30 seconds, now turn it back on and it will be out of limp mode.

How do you reset the security on a 2002 Dodge Ram 1500?

To reset the alarm on the Dodge Ram 1500 you need to lock all the doors, then unlock the driver side and put the key into the on position. Now turn it off and then back on twice and it will reset.

How do you reset the computer on a Dodge Cummins?

Put the negative cable clamp back onto the negative battery terminal and tighten the nut with the end wrench. Put the key into the ignition and turn over the engine. Examine the instrument panel to make sure all service and warning lights have shut off. If so, the computer has been reset.

What is a 3057 bulb used for?

What Is The 3057 Bulb Used For? The 3057 bulb is compatible with many car light types, where it is ideal as a backup light bulb, brake light bulb, parking light bulb, taillight, and turn signal lighting.